garmin 60cx/ backroad gps maps question.

[sarg]

:confused:so i bought the backroad maps for my gps and i go to use it and its not showing any logging road. i went throw my setting and changed some stuff but the roads still dont show up. can one let me know what im doing wrong or if i got a bad card or whats.:confused:
thank
sarg:-D

[338 winmag]

Did you zoom right down? they don't seem to be as well defined like Topo Canada. Still trying to get accustomed to it myself.

[sarg]

ya i tried that and nothing.

[338 winmag]

If you like to send me some co-ordinates or land marks and I'll check on my 76csx for comparison.

[tonywtc]

change you map setup to "most detail" are the logging roads the only thing its not showing? there is also an update available within the last month or so that names a bunch of logging roads, try installing the update

[Tiptoe]

Try to e-mail their support at gps@backroadmapbooks.com. They have been very prompt helping me out when I have sent them questions.

[sarg]

If you like to send me some co-ordinates or land marks and I'll check on my 76csx for comparison.
i was in skagit valley and up east harrison both place showed no roads or trails

[sarg]

Try to e-mail their support at gps@backroadmapbooks.com. They have been very prompt helping me out when I have sent them questions.
i sent them a massage tonight so hopefully i hear from them sooner then later.

[338 winmag]

I'm showing lots of trails and side roads in the Skagit Valley. As Tony pointed out, check out the detail level your set at.

[bc mike]

I have the same system. All the above and check that your sd card is locked in place. Sometimes my buddys sd card slides out of place and he looses detail.