Smoking...

[IronNoggin]

Third round since I got back home:

https://i.imgur.com/o00Pvj6.jpg

https://i.imgur.com/ZZJhIe7.jpg

Marvelous!

https://i.imgur.com/lMlfCMa.jpg

Cheers

[high horse Hal]

wew, nice load! I'm stuck buying local retail to get a taste of the good snacks
Does the smoker need or have temp control or jsut cold?

[IronNoggin]

Does the smoker need or have temp control or jsut cold?

That's my last build based on a 1960's Hospital Food Warmer.
Near 400 pounds of stainless & insulation.
Thankfully on wheels!

I run a PID controller which controls one or two (depending on product) commercial grade electric hot plates.
It constantly checks internal product temp and internal smoker temp.
And pre-set rather limitless temperatures / times, and has it's own shutdown system when desired product temperature is reached.

For cold smoking, I run a Bradly Cold Smoker attachment:

https://i.imgur.com/HcvXzjd.jpg

Cheers,
Nog

[cdub]

The Auber PID controllers are great. I bought one for my new build this summer and control is far superior over past builds. Temps are flat lines now and are within .5 to 1 deg accuracy when comparing separate temp probes.

[IronNoggin]

The Auber PID controllers are great. I bought one for my new build this summer and control is far superior over past builds. Temps are flat lines now and are within .5 to 1 deg accuracy when comparing separate temp probes.

Absolutely. Same brand I use, however somewhat dated.
Collected it for my previous to this build.
Still going strong.
VERY worthwhile product IMO.

Cheers