View Full Version : 3/8" threaded (camera) gun 'V' rest for tripod
Jamesonm
09-20-2020, 03:45 PM
Howdy y'all... anyone find a source for a V or U yold gun rest that fits into a 3/8" 16 unc thread for my spotter tripod?
Figured I'm carrying the tripod anyway may as well make it more functional.
Cheers!
operator jon
09-20-2020, 08:25 PM
Make one!
I used a piece of aluminium angle, drilled a hole through it to use a 3/8" socket cap screw and used a 3/8" rod connector. Use some red locktite on the bolt threads and tighten it up.
Covered the angle with some soft rubber.
Jamesonm
09-20-2020, 09:14 PM
Hmm good point! If I can find one for 10 bucks I'd buy one. However being hunting I bet it's closer to 30.
Beaver Skin
09-21-2020, 08:51 AM
Outdoorsmans has one. Made to fit their dovetail system but I'm pretty sure it's threaded underneath for standard tripod mounting.
BRvalley
09-21-2020, 10:52 AM
can find lots on amazon, the one I use was around $15, but of course can get more expensive ones too
Jamesonm
09-21-2020, 09:08 PM
Ended up building one that I'm pretty happy with.
Thanks for the recommendations everyone!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.