9.3 x 62

[Koot]

I am getting a 9.3 x 62 built on my husqvarna 30-06. My reamer is
in but my reloading components haven't arrived yet.
Is there any body out there that loads the 9.3 that is able to load me up a few dummy rounds for my smith? I am looking at shooting the 250 ttsx and maybe a 286 tsx. Haven't quite decided on what 286 grn yet. Suggestions?
i am 8 hrs away from any large stores that may carry the 9.3 ammo so i thought i would throw it out there.
Cheers,
Koot

[Moose Guide]

I think that I have 0ne empty shell but none loaded, where are you? What happened to your original barrel?

[mooze]

I hope you kept your 30-06 brass as it is easy to neck up to 9.3x62 (30-06 =7.62x63 in metric).
What do you want dummy rounds for? If you load Tsx/TTSX seat them 2mm of the lands and accuracy will be fine.

I am using Accubonds in 250gr with Varget or CFE 223. and KJG with RL 7 or RL 10 (if you have a longer barrel, mine is only 50 cm).

or if you order things in
https://www.tradeexcanada.com/content/w47a-woodleigh-bullets-93-cal-250gr-rnsn--
and lapua brass from Hirsch Precision

[Everett]

If your East Kootenays I can help you out.

[Salmon Belly]

Todd Bartell loads for that round

[Koot]

Thanks guys. I have a ton of 30-06 brass . Smith wants loaded dummy round so i said i would get a few if i can.
Everett I am in Rossland , 2 and a 1/2 hrs from cranbrook.Thanks that would be great.

[Everett]

I am in Kimberley PM your number and I will see if I can load up a few of what you need and mail them over. Unless you are in the neighbourhood than just drop in.

[Spy]

HBC at its best ��

[B.C.Boy(100%)]

Incoming PM.

[Koot]

Thanks Everett,
Received the dummy rounds .

[Everett]

The longer one should me the maximum length for a 1600 magazine