New strings
So my son got a new set of strings and is itching to get them on. I think I am going to do it myself but was wondering if anyone here that has done it before has any advice or tips? My plan is to take pics of both cams and the string connections before as well as all measurements as they stand now, (even tho the bow isn't to spec atm). Then I am only going to change one at a time. I should end up very close to the specs that it is now but then I am going to do my best to adjust the bow back to factory specs as best I can and then start the tuning all over. I have a draw board as well as a portable press.
Right now one yoke cable only has one twist in it and the other is fairly twisted and this seems wrong to me. So after I get everything on I am going to attempt to get even twists in both and then yoke tune so that there is no cam lean at full draw for my starting point on a tune. One thing I am unsure of is how do you adjust brace height if needed?
His bow is a Hoyt Rampage 50-60# and has the fuel cam and a half set up.
A Pine needle falls. An Eagle sees it. A Deer hears it. A Bear smells it
Reply With Quote