Cutting carbon arrows

[Avalanche123]

Any suggestions on how I can cut my carbon arrows without spending alot of money on an expensive saw?

Thanks in advance.

[Alpine Addict]

Bring them into chilliwack dart and tackle if you live close by. And I will cut them for free. just pm me if your gunna.

[Bow Walker]

Check this little beauty out. It's what I use at home.

http://www.harborfreight.com/cpi/cta...emnumber=42307

[Stone Sheep Steve]

I just use "Vise-Grips". Works like a charm.

SSS

[jessbennett]

dremel. or rotary cutoff tool. works well. can get them for about 15 bucks or so,.

[Avalanche123]

Thanks everyone. Bow Walker, where did you get that saw?

[Bow Walker]

I bought mine from a friend of my brother. You can order direct withourt undo stress or you can get them from Ebay.

I forgot to mention - DO NOT cut carbon shafts with anything other than a proper saw that has at least 5000 rpm.

[Avalanche123]

I went out and purchased a dremel. It should do the trick.

[Bow Walker]

Dremels - properly set up - have been known to work quite well. Good luck.

[Ron.C]

If you are using anything but the proper saw, make sure you carefully inspects the cut off ends before gluing inserts in. Dremels often tend to cause the carbon to splinter or crack at the ends which is bad news for and just a recepie for an arrow to shatter or drive a carbon splinter in your hand. This is exactly what happened to a fellow I shot with in Nanaimo last year