Cargo Trailers & Side x Side...

[elkrub]

Anyone Modify there roll cage on a sxs to fit through the door on a cargo trailer?

[warnniklz]

I've seen it done before...

I would also call UTV Canada to see if they have any aftermarket ones around.

[canadiancon]

My rzr 1000 fit into my cargo trailer, depending how much room you need you could suck the suspension down to drive it in.

[albravo2]

The reason I've still got my 2009 Rhino is it fits into my cargo trailer without any work. I looked at some new ones last spring but they wouldn't fit.

I did think of taking the air out of the tires if it was close but I don't relish having to do that every time. I'd probably mod my roll cage.

[MOUNTAIN MICKEY]

Chopped the rear section of the cage down 6 inchs on my RZR. It fit in with no mods but when I get around to puttin on my 27s it aint gunna go in. Like the looks of the chopped cage better than stock. First chop was 4 1/2 inches, then a couple months later it came down some more.

[Redthies]

I built drop ramps so the tires are 6” lower right until they pop up into the trailer. At that point the cage is inside the trailer.

Mind you, I don’t use a SxS or quad to hunt, so it’s moot. I have boots instead.

[emerson]

I got a cargo trailer 6” trailer than stock. Not much help if you already have one though.

[RambleOn]

Tall trailers suck am up. Steep ramp. Lower trailers need to be slammed up front to get the angle of rotation right to take the height.

[dmaxtech]

Tall trailers suck am up. Steep ramp. Lower trailers need to be slammed up front to get the angle of rotation right to take the height.

He meant the roof is 6” taller than stock.

[Dirty Steve]

Let the air out of your tires