Thanks guys.
I’ll check out the fastenall stuff for sure. I’ll have to take a look at the Kni-co stuff for ideas.
Printable View
Thanks guys.
I’ll check out the fastenall stuff for sure. I’ll have to take a look at the Kni-co stuff for ideas.
Looks awesome!
Looks really good!
I may have enough titanium sheet metal to make one like this.
Somewhere have a box of rivets too.
The vent probably doesn’t need to be anything fancy. Do you think you could cut the bottom portion of the door(stove side) on an angle and close the door all the way for no air flow and open the door part way for some airflow?
Well since I finally got around to finishing this, I set it up while camping this weekend to test it out. I ended up just ordering the remaining parts I needed from Seek Outside. Not sure what it weighs but it feels a little heavier than I'd hoped but as I mentioned previously the titanium sheet metal I used is 0.025" and I think the commercial ones probably use 0.020". I also went with a bit longer stove pipe in case I want to get a bigger tent for family use.
https://i.imgur.com/ITWSWXz.jpg?1
https://i.imgur.com/xuSSfwo.jpg?1
https://i.imgur.com/0exWo0o.jpg
https://i.imgur.com/RCvwEKJ.jpg?1
Should be nice for next week's hunting trip!
Seriously impressed with your skills and thinking THANK YOU for sharing.
I have a small stove for heating water..meals made by a Russian scientest bought as a gift..absurdly small,light and works incredibly well.
Srupp
I was hoping to make one similar, but I can't find my titanium sheet metal pieces.
I may have lost them during moving last fall.
Looks awesome. Make sure to post a long term review once you had a chance to use it a few times
Thanks guys. I'm heading out for a week tomorrow so I will get some quality time with it to see what works and what doesn't.