View Full Version : How to sharpen Montecs?
pupper
06-23-2006, 04:47 PM
I have some new montec g5 broadheads I would like to sharpend up.
I was wondering if my diamond stone I used for sharpening my draw knife would work?
what type of motion do you use? just a forward push on the stone? Do you have to make sure each side gets the same amount of strokes?
Do I have to use water or oil for lube? When I used it for my draw knife I didnt have to use any.
thanks for the help
Bow Walker
06-23-2006, 07:06 PM
I have some new montec g5 broadheads I would like to sharpend up.
I was wondering if my diamond stone I used for sharpening my draw knife would work?
what type of motion do you use? just a forward push on the stone? Do you have to make sure each side gets the same amount of strokes?
Do I have to use water or oil for lube? When I used it for my draw knife I didn't have to use any.
thanks for the help
Being an ex-meat cutter of some 28 years, I generally use an oil stone for sharpening my broadheads, including the Montecs that I just traded Cowboyup69 for. If the oil stone does not have the correct angle for the blades, I will resort to my low speed wet grinder to put a useful angle on the heads.
When using my oil stone I use both forward an backward strokes, trying for an equal number of each. I finish with a few LIGHT strokes in both directions and then go to my leather strop to do the final touches - which are very light.
I hope this helps you.
Dan.
pupper
06-23-2006, 10:15 PM
what about the special montec sharpner?
is that a marketing ploy or a useful way to sharpen them?
has anybody used them?
Triggerman
06-23-2006, 10:50 PM
A flat stone is all you need. It works perfectly!
http://www.g5outdoors.com/Products/ProductDetail.aspx?productid=4
Bow Walker
06-24-2006, 05:45 AM
From all that I have heard - the G5 stone works well. I just don't think it is necessary if you have the skill and the patience to "do-it-yourself".
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.