Loading Bench Beef-up!!

[.308win]

Will, with Bear season just around the corner, and the ammo a little low from some winter practice, I thought I'd size some brass, only to descover that everytime I sized one I notice that my press was moving!!:icon_frow Actually the whole counter top was moving, about 1/16 to 1/8" so I did a little work on her, I sandwitched 3 pices of 1/2" plywood between 2 pieces of 1/8" X 6" x 11" steal plates, added some extra braces and and a whole lota screws!!:biggrin: It dosen't move anymore.......now I have to be carefull, press to hard now and i'll flip the shop!!!:biggrin:

http://i126.photobucket.com/albums/p101/newfieguy1/IMG_3626.jpg

http://i126.photobucket.com/albums/p101/newfieguy1/IMG_3627.jpg

http://i126.photobucket.com/albums/p101/newfieguy1/IMG_3628.jpg

Perry

[quackquackbang]

Now you should be able to lift yourself off the chair!!!!!!:lol:

[Dirty]

You should have done it right the first time, didn't your parents teach you anything.:D

[.308win]

You should have done it right the first time, didn't your parents teach you anything.:D

True...true:biggrin: Thought I had done a great job the first time, when I was at the end of the stroke, i look to the side and just happen to notice the top moving!! Lesson learned!!:-D

Perry

[Dirty]

True...true:biggrin: Thought I had done a great job the first time, when I was at the end of the stroke, i look to the side and just happen to notice the top moving!! Lesson learned!!:-D

Perry

This is priceless. Are you talking about your first piece of pie or a reloading bench?:mrgreen:

[.308win]

Man.....walk right into that one!!!:oops::biggrin:

Perry